Customize your Budget Cordless 2" Routeless Faux Wood Blinds

The blind is mounted inside the window opening for a clean, tailored look. When selecting the size of your blinds, enter the exact dimensions of your window opening. Do NOT enter the size of an old/existing blind. The factory will make a 1/2" deduction off the ordered width for a proper fit. Please make sure your window meets the minimum inside mount depth required to accommodate the brackets, or the flush mount depth if desired. Depth requirements can be found on the product page.

The blind is mounted on the wall or window trim outside and above the window, covering an area larger than the window opening. Outside mount is required if your window opening is not deep enough to install the blind as an inside mount or if you want to make your window appear larger than it is. When measuring your blinds make sure to adjust the size for proper overlap.

Best for Kids™ - The cordless lift is operated by lifting the bottom rail to raise it and pulling on the bottom rail to lower it. Ideal for homes with children or pets, cordless lift completely eliminates the dangling cord hazards of traditional cord-controlled window blinds.

Best for Kids™ - Traditional method of tilting the slats open or closed. When you rotate the wand in one direction, the slats open, and when you rotate it in the opposite direction, the slats will close. Wand Tilt is available on the left side only. Blinds less than or equal to 72" Height will have a 24" wand; Blinds greater than 72" Height will have a 36" wand; Blinds less than 36" Width and greater than 72" Height will have a 2-piece 36" wand.

2 1/2" Crescent valance with a smooth and curved face is a standard feature. Outside mount valance with side returns and side return corner caps is pictured.

Routeless, also referred to as "No Holes Privacy", has notches on the front and back of each slat for the cords, which take the place of the center route holes, allowing for increased privacy and light control. Slats can move freely and may need adjusting. Slats can be fully removed. Not recommended for mounting on doors.

Mounted on the wall or door to support the bottom rail of the blinds, preventing the blinds from swaying. Included with all orders.

Spacer blocks are used with mounting brackets to provide 3/8" of additional space between the mounting surface and the blinds. Typically used for clearance when installing blinds above raised trim, molding or window framing. Available on outside mounts only.